b'Indoor Kit Assembly InstructionsPartsABASEB TOP & ADAPTOR C POLES D FLAG1 STEP 1 - POLE 2 STEP 2 - ATTACHING THE TOP2Connect the 2 piece pole by screwing them together using the brassIf you are using a topper like an eagle or spear, you will need to secure screw joints. it to the pole.Place the topper on the pole and gently tighten the small First screw the top into the top adaptor. screw until the topper is secure.Locate a small screw located on the side of your topper and unscrew it.3 STEP 3 - HANGING YOUR FLAGYou need to locate two important pieces before you begin:#1- The Leather Tab #2- Hanging peg Slip the ag onto the pole sleeve untilyou see the leather tab. Slip the On the top inside of the sleeve of your ag there will be a gray leather tabNear the top of the pole there is a small brass pegleather tab over the hanging peg and pull down gently until the leather tab with a small slit. about .25 in diameter. is secure.Leather TabHangingPegSleeve openingK I T A S S E M B L Y4 STEP 4 -ATTACH THE ROPE AND TASSEL 5 STEP 5 -PLACE POLE IN BASEFold the cord in half so that the two tassels hang loose at one end.Place the assembled pole into your base.If the pole is not secure in the base, insert the Slide the other end through the cord and tassel ring about 6 so a loop is formed.Feed theplastic adaptor rst and then insert the pole.tassels through the loop and pull until the loop is tight around the ring.355'